Keys On Top Of The Tv - Philips 28PW9617 Instruction Manual

B

Keys on top of the TV

Should your remote control be lost or broken you can still
change some of the basic picture settings with the keys on
top of the TV.
Preparation
4
A
A
M
P
Surround loudspeakers
There are two surround loudspeakers supplied. One is the
active loudspeaker A.The other loudspeaker B is a passive
one which has to be connected with the active
loudspeaker.
•
The slide channel switch
loudspeaker has been set default to channel 1 in the
factory. See also Sound Setup, p. 9.
•
Connect the active to the passive loudspeaker with the
supplied speaker cable
Insert the marked wire into the openings of the same
coloured connector clips on both speakers. Do not insert
the wires too far.
•
The Surround sound loudspeakers can be located behind
or to either side of the listener.The front of the
loudspeakers do not have to face the listener.
The distance between the TV and the surround speakers
should not exceed 15 m.
Note: In rare occasions people moving around close to the TV
may interfere with the sound transmission.
•
Set the position switch
loudspeaker is positioned to the right side of the listener,
to the left if it is positioned to the left side of the listener
(seen from the point of view of watching the TV).
•
Connect the active loudspeaker to the mains with the
mains cable .
•
Switch on the active loudspeaker with the
switch .
POWER
The red indicator at the front of the active surround
speaker shows that the speaker is in standby.
During sound transmission the indicator turns to green.
10-15 min. after the sound transmission of the TV has
stopped, the indicator turns back to red to indicate the
low power standby.
To switch the active speaker off, use the
Press the M key repeatedly to select
,
Colour, Contrast Treble
Press the P - or + keys to carry out the selected adjustment.
When the menu adjustment is not displayed, the P- or +
keys enable you to select the TV channels, the
keys to adjust the volume.
The selected adjustment automatically switches off when no action
has been executed for 10 seconds.
at the bottom of the active
.
to the right if the active
switch.
POWER
Volume, Brightness,
and .
Bass
- or +