Preparation; Keys On Top Of The Tv - Philips 36PW9607 Manual

B

Preparation

4
A
REAR
Surround loudspeakers
There are two surround loudspeakers supplied. One is the
active loudspeaker A.The other loudspeaker B is a passive
one which has to be connected with the active
loudspeaker.
•
Connect the active to the passive loudspeaker with the
supplied speaker cable
Insert the marked wire into the openings of the same
coloured connector clips on both speakers. Do not insert
the wires too far.
•
The Surround sound loudspeakers can be located behind
or to either side of the listener.The front of the
loudspeakers do not have to face the listener.
•
Set the position switch
loudspeaker is positioned to the right side of the listener,
to the left if it is positioned to the left side of the listener
(seen from the point of view of watching the TV).
•
Connect the 3,5 mm jack cable with the connector at the
back of the active surround loudspeaker and with the
black and red
REAR R
•
Connect the active loudspeaker to the mains with the
mains cable .
•
Switch on the active loudspeaker with the
switch .
POWER
The red indicator at the front of the active surround
speaker shows that the speaker is in standby.
During sound transmission the indicator turns to green.
10-15 min. after the sound transmission of the TV has
stopped, the indicator turns back to red to indicate the
low power standby.
To switch the active speaker off, use the
.
to the right if the active
or outputs at the back of the TV.
L
switch.
POWER