Philips 28PW9617 Instruction Manual page 10

Sound Setup menu
Sound setup
Auto Surround
Wireless Surround
Extra front speakers
Distance to front
Distance to rear
Auto Surround
Sometimes the broadcaster transmits special signals for
Surround Sound encoded programmes.
The TV automatically switches to the best surround sound
mode when
Auto Surround
However it is possible to overwrite this setting.
Wireless Surround
The system has already been configured in the factory to
work properly.
In rare circumstances, interference from external RF
(wireless) equipment such as RF headphones, mobile phones
or remote controls for lights, may occur.Then it may be
necessary to shift to another wireless channel.
Use the cursor left/right to select another channel.
Important:
Always be sure that the active surround speaker and the
Wireless Surround setting are switched to the same
transmitting channel. Otherwise no sound or only a
distorted sound will be heard on the surround speakers.
When the TV is tuned to a channel in the neighbourhood of
864 MHz (433 MHz in case you purchased a TV with a
typenumber in the range 28-32PW9617/01 or /58 or 32-
36PW9767/01 or /58), the transmitter is switched off because no
RF surround sound is possible. This is necessary to avoid interfered
picture.You can improve the picture quality by using the
suppressor aerial cable supplied.
In rare cases, when no RF surround sound is possible or
when there is too much interference, use the wired back up
solution with a 3.5 mm stereo jack. In this case select Off in
the Wireless surround menu item. See Connect Peripheral
equipment, p. 28.
is switched .
On
Extra front speakers
See Connect Extra loudspeakers, Amplifier, p. 30.
If no extra front speakers/amplifier are connected, do not
change the predefined factory setting which is
Distance to front
Select the distance between the TV and the place you sit to
watch TV.
Distance to rear
Select the distance between the rear surround speakers and
the place you sit.
To exit from the menu press the
.
No (TV)
key repeatedly.
Installation
9