Table of Contents
Advertisement
stereo system
RCA audio
cable
a na,ogaadio
digita,
aud
1o
input jacks
input jack
digital
audio
coaxial
cable I
Dolby
Digital
decoder,
MD deck or DAT deck
AUDIO OUT
DIGITAL AUDIO OUT
Connecting
to a Dolby
Digital
decoder
for Dolby
Digital
audio
output.
Connecting
to other
device (an MD deck
or DAT deck etc.) without
Dolby
Digital
decoder.
× To complete
these settings,
refer to pages 20-21.
Note:
The audio source on a disc in a Dolby Digital multi channel surround
format cannot be recorded as digital sound by an MD or DAT deck.
By hooking this unit up to a Dolby Digital decoder, you can enjoy
high-quality
Dolby Digital multi channel surround sound as heard in the
movie theaters.
Playing back a DVD using incorrect settings may generate noise distor-
tion and may also damage the speakers.
rear of TV
rear of the unit
external tuner
(cable/satellite box)
Using the unit with a cable/satellite
box
1. Connect
an RCA audio
and video
cables to the audio
and
video
output
jacks of your
cable/satellite
box and to the audio
and video
input jacks at the rear of the unit.
2.
Press [INPUT SELECT] on your
remote
control
until %1" is
displayed
on your TV.
Note:
• Your cable/satellite
box can be accessed only by connecting it to L1
(rear panel jacks) of the unit. Even if the unit is turned off, the signal
from the externa tuner is output to the TV through the unit.
L1 :
Rear panel terminals
L2:
Front panel terminals
Refer to
Front & Rear Term nals
on page 9 for more information.
Special
note
when
connected
to a cable/satellite
box:
• Only the active
channel
on your cable/satellite
box may be
viewed
or recorded
when connected
to this unit.
Do not change
channels
during
a recording.
You cannot
record
on channel
while
viewing
another.
• Always use the LEFT (white)
audio
output
jack from the external
tuner to ensure that the audio
is mixed down
correctly
to mono
for this unit. If you use the RIGHT (red) jack, you will record the
right
audio only.
7
EN
Advertisement
Table of Contents
