Table of Contents
Advertisement
Note:
Specification and
design;
functions and features
;
unit illumination; colour and display
segment are subject to change without prior
notice.
Photos and drawings on gift box or operation
manual might be varied from the exact unit. Depends on the input devices, operation might be
varied from the operation manual described.
SIMPLE TROUBLE SHOOTING
PROBLEMS, CAUSES & SOLUTIONS
No power
- Check and make sure the connecting wires are connected correctly
- Check whether the fuse is blown. Replace with the proper value fuse if necessary.
No sound
- Check and make sure the s eaker wires are connected correct!
.
No picture
- Check whether the video wire is connected to the video
device.
Unit hang-up
- Press the RESET button to reset the unit to its default sta e.
No function when pressing the buttons or TFT screen
- Press the RESET button to reset the unit to its default sta e.
Poor effect or unable to receive radio / TV
- Check whether the radio/ TV antenna is inserted or properly connected.
- Antenna may not be the proper
length.
Make sure the antenna is fully
extended.
- Antenna ma be oorl
rounded. Check and make sure the antenna is ro erl
rounded.
Stereo cannot be received under radio mode
- Tune the radio frequency accurately.
- The broadcasting signal is too weak, set the mode to
MONO.
Disc inserted but cannot play
- Check whether the disc inserted upside down.
- Check whether the disc is dirty or badly cracked.
- Lens is dirty. Clean lens by usinq the lens clean disc.
Abnormal moving, skipping or sound during playback
- The disc is dirt or dama ed. Wi e the disc with ad
soft cloth or re lace a new disc.
Remote handset does not work
- Replace new battery of the remote handset.
- Point the remote handset directly at the remote sensor of the main unit.
- Clean the surface of the remote sensor.
Bluetooth not operated
- check the devices are linked u correct!
.
Picture without colour or no sound under disc / TV mode
- Im ro er settin of colours stem at TV mode. Set a ain to "PAL; "SECAM" or "NTSC"
GPS not operated
- check micro SD card with navigation software (map) has been inserted into SD card port for GPS.
- check GPS antenna connected properly.
Note
After the above efforts, if the unit still cannot be worked normally, consult your service dealer.
Never attempt to disassemble the unit by yourself. No service part inside the unit.
[ 25]
Advertisement
Table of Contents
