Advertisement
Installation
ELECTRICAL SHOCK HAZARD – Turn off power
at the main service panel by removing the
fuse or switching the appropriate circuit
breaker to the OFF position before removing
the existing thermostat (if applicable).
A. Thermostat Location
The thermostat is a sensitive electronic
instrument. For accurate temperature control
and comfort, the following should be
considered:
1. Locate the thermostat on an inside wall
about five feet above the floor. Pick a dry
area where the air circulation is good.
2. Do not install the thermostat where
there are unusual heating conditions
such as direct sunlight, near heat
producing appliances (TV, radio , wall
lamp, etc.), or a furnace or air
conditioner supply register.
3. The Thermostat must be installed in a
vertical position.
B. Installing the Thermostat
1. Place the thermostat mounting plate
against the wall where the thermostat
will be mounted orienting it as shown
below.
2. Affix the mounting plate to the wall
using two screws. Wall anchors are
included if needed to secure the
mounting plate to the wall.
3. Wire the thermostat to the
motorcoach:
Refer to the section "Wire Labeling
and Connectors" section in this
manual for wiring the thermostat.
Refer to the section "Dip Switches"
section in this manual to set the dip
switches to the appropriate settings
for the equipment installed on the
coach.
4. Place the thermostat on the mounting
plate and gently slide the thermostat
down to lock the thermostat onto the
mounting plate.
5. Turn on the power to the thermostat.
REFER TO THE OPERATION GUIDE FOR
THERMOSTAT DISPLAY INFORMATION &
THERMOSTAT OPERATION
Advertisement
