Yaesu FT-1000 Operating Manual page 45

Hide thumbs Also See for FT-1000:

Table of Contents

6. Installing Internal Accessories - BPF-1 Bandpass Filter Module

BPF-1 Bandpass Filter Module

©) Disconnect the power cord from the transceiver.

( Referring to the photo at the top of page 40 remove

the three screws on each side, and the two at the top

of the rear panel, and remove the top cover.

[Now referring to the drawing at the right, remove the

four screws affixing the dummy subpanel on the rear

panel, and remove the subpanel.

Locate the three empty plugs on the cable harness

inside the BPF-1 mounting hole, and hold these out

of the way while sliding the BPF-1 about half way

into the chassis from the rear, so you can connect the

empty plugs to the BPF-1 as shown in the drawing

below: each plug mates with a connector having a

matching number of pins. Note: the cables must not

be routed over the top edge of the rear panel!

[Slide the BPF-1 the rest of the way into the chassis,

and affix it in place with the four screws removed

above, using Care not to squash any of the wires.

you wish to have the FRONTEND selector on the front

panel control the attenuator in the BPF-1 (in tandem

with the main receiver attenuator).

XS 20.9003

Ss. ric

Unless you intend to operate split with a separate

receive antenna, you will want the front panel RX ANT

button to select the BPF-1| with its antenna connect-

ed to the SUB RX ANT coaxial jack (as opposed to the

RX ANT phono jack). To do this, change the position

of $1001 on the RF Unit, as described on page 9,

before replacing the top cover and its ten screws,

page 43

Table of Contents