Yaesu FT-1000 Operating Manual page 17

3. Controls & Connectors - Front Panel Controls
(30) CLAR Pushbuttons
Pressing the RX button activates the CLAR knob
(below this button), to allow offsetting the receiving
frequency temporarily (see (26), above). The TX button
provides the same function for the transmit frequency.
If both buttons are pressed, the receiver and transmitter
are both offset from the original frequency. Pressing the
CLEAR button zeros any offset tuned by the CLAR knob,
Each memory and vfo retains all clarifier settings inde-
pendently.
(31) TUNER 2-Position Pushbutton
Pressing this button so that its LED is lit places the
antenna tuner in line between the transmitter final amp-
lifier and the main antenna jack. Reception is not af-
fected. The tuner is also activated when the START
button (below) is pressed.
(32) START Momentary Pushbutton
Pressing this button while receiving in an amateur
band activates the transmitter for a few seconds while
the automatic antenna tuner rematches the antenna for
minimum SWR. The resulting settings are automat-
ically stored in one of the antenna tuner's 39 memories,
for instant automatic recall later when the receiver is
tuned near the same frequency.
(33) M SCAN Pushbutton
Activates scanning of the memory channels. Also
used together with the FAST button to set/reset Scan
Skip status of a recalled memory channel.
(34) Right Side LED Indicators
The WI sWwR LED lights when an impedance mis-
match is detected at the main ANT jack. Avoid transmit-
ting until the problem has been corrected,
The WAIT LED lights while the antenna tuner is
tuning, and flashes briefly when changing frequency,
as the main cpu sends new frequency data to the anten-
na tuner coprocessor: this does not affect operation.
The CW TUNE LED is a visual tuning indicator for CW
Teception on the main receiver, which lights in synch-
ronization with a signal tuned to the center of the IF
passband during CW reception.
(35) Digital Display
The display shows, from left to right, special oper-
ating status (CAT SYSTEM, DUAL, SPLIT or GEN (eral
coverage), VFO, MEM Or M TUNE mode of the main receiver;
main receiver operating frequency, clarifier offset,
memory channel number; and sub vfo mode and fre-
quency.
(36) Left Side LED Indicators
The TRANSMIT LED glows red when the transmitter is
activated. The MAIN BUSY and SUB BUSY LEDs glow green
when the main or sub vfo squelch is open, respectively.
(37) Meter
The 7-function multimeter normally indicates main
receiver signal strength on the top scale, and one of six
parameters (selected by the METER selector) during
transmit on the lower scales.
page 1S