Microwave Measurement - Sharp R-6R50 Service Manual

§-6R50(W}/{B)}
3-6G50(W)}/{B)
3-6G52(W)/(B)
3-6R70(W)/(B)
—
(Refere to Figure C-3.)
For 1st latch switch;
switch.
For other switches;
The switches can be removed by doing proce-
dure as same as above.
CAUTION:
WHEN
REMOVING THE
SWITCHES,
DON'T BREAK
THE TABS OF
THE
LATCH HOOK,
Laich hook
Stop switch
Push backwards
2nd latch
switch
Push upwards
Pull forwards
Push backwards
Monitor switch
Tst laich
"== switch
Push leftwards
Figure C-3. Switch Removal
Stop switch
Monitor
switch
tsi latch
swiich
Switch Jevar
Open lever
Open button
si
peat. pee,
4 i
Rs
Q
'
R-6R50{
R-6G50|
R-6G52
R-6R70(
MICROWAVE MEASUREMENT |
After adjustment of door latch switches, monitor
switch and door are completed individually or collec-
tively, the following leakage test must be performed
with a survey instrument and it must be confirmed that
the result meets the requirements of the performance
standard for microwave oven.
REQUIREMENT
The safety switch must prevent microwave radiation
emission in excess of 5mW/cm2 at any point 5cm or
more from external surface of the oven.
PREPARATION FOR TESTING:
Before beginning the actual test for leakage, proceed
as follows;
1. Make sure that the test instrument is operating
normally as specified in its instruction booklet.
Important:
Survey instruments that comply with the require-
ment for instrumentations as prescribed by the per-
formance standard for microwave ovens must be
used for testing.
an
Recommended instruments are:
NARDA 8100
NARDA 8200
HOLADAY HI]! 1500
SIMPSON 380M
. Place the oven tray into the oven cavity. a
. Place the load of 275 +15ml of water initially at
20 +5 °C in the center of the oven tray. The water
container should be a low form of 600 mi beaker
with inside diameter of approx. 8.5cm and made of
an electrically non-conductive material such as
glass or plastic.
The placing of this standard load in the oven is im-
portant not only to protect the oven, but also to in-
sure that any leakage is measured accurately.
. Close the door and turn the oven ON with the timer.
set for several minutes. If the water begins to boil
before the survey is completed, replace it with
275m! of the coo! water.
. Move the probe slowly (not faster that 2.5cm/sec.)}
along the gap.
. The microwave radiation emission should be meas-
ured at any point of 5cm or more from the external