6.2.2.7. Installation of Filter Ring
1. Install Filter Ring.
2. Tighten 3 screws (E) in numerical order by using the torque driver with specified torque.
①
③
Screw Order
Torque
6.2.2.8. Installation of Decoring Unit
1. Insert 3 Pins of Decoring Unit to 3 Holes of Filter Ring.
・Use new one, do not use the one which is removed.
・Double-stick tape sticks to Decoring Unit of the repair part. Remove the old double-stick tape from Filter Ring.
2. After installing Decoring Unit, use a soft cloth to press it into place.
Hole
Screw (E)
②
Filter Ring
Screw (A) x 3
① → ② → ③
10.0 ± 1.0 N ・cm
Decoring Unit
(Reverse side)
Pin
Hole
6
19
Decoring Unit