PowerBlock Elite EXP Owner's Manual page 4

Safety Features And Proper Use
1. Removing or replacing the handle
and weights from the nest must be
done in a straight motion (Image 1).
2.Tilting the handle when lifting/nesting
may jam the assembly (Image 2).
3. Be sure when selecting weight that the
selector pin is fully inserted and with the
desired weight/side rail (Image 3). Be
careful to cross pin (Image 4).
WARNING
Always check the selector pin to make
sure it is fully inserted and completely
engaged before lifting the dumbbell to
avoid injury (Image 3). If the selector pin
disengages from the side rails, stop use
immediately. Place PowerBlock on
nearest at surface and fully engage
selector pin securely to the side rails.
Failure to maintain full and correct
contact between selector pin and side
rails may result in weights falling and/or
injury. Do not use the PowerBlock
without the tether cord being in good
working condition and attached to the
top side rail and selector pin. Weight
selector pin may fall out of PowerBlock if
used without tether cord and may result
in falling weights and/or injury.
4. Your PowerBlock features a tether cord
which attaches the selector pin to the weight
plates on the #1 or top most weight plate
side rail. The tether cord will prevent the
selector pin from being misplaced. The
tether cord also serves as a safety retainer for
the weight selector pin in the event the
selector pin loses contact with the side rails.
WORLD'S BEST DUMBBELL
Do not use if weights are jammed.
Using while jammed may result in
falling weights and/or injury.
®
Image 1
WARNING
Image 3
Image 4
Image 2
3