Advertisement
HANDLER
SAFETY
INSTRUCTIONS
1 . GROUNDING INSTRUCTIONS
This tool should be grounded while in use to protect the operator from electric shock. The tool is
equipped with an approved three-conductor cord and three-prong grounding type plug to fit the proper
n (or greon and yellow) conductor in ho cord isthe grounding wie.
wire ta lve terminal. I yo
150 vote i t has plug that looks lie that shown in sketch (A) in Figura 1 Unit is for use on less 1
I f ts for use om 180 to 250
adapter is not recommended
FIGURE 1
GROUNDING METHODS
四
©
ES)
ο
lay
Sunersox
©
TOOL SAFETY INSTRUCTIONS
1. Keep Work Area Clean
Cut
2. Avoid Dangerous Equipment
Don't expose power tools to rain. Dont use power
foals in damp or wet locations, Keep work area well
n
3 . Keep Children Away
An visitors should be kept safe distance from work
area and appliance.
4 , Store dle Tools
When nat in use, tools should be stored in dry,
high, and locked location out ofthe reach of children,
5. Don't Foree Tool
It wll do the job better and be safe at the rate for
ich it was designed,
6. Use Right Tool
Dont force small tool or attachment to do the job
of a heary-duty tol
7. Wear Proper Apparel
Do not wear loose clothing or jewelry which may
get caught in moving parts. Tie back long hair or
Use a proper hai net.
ad areas and benches invite accidents
8. Use Safety Glasses
Use safety glasses with al rotating tools, Also use
a face or dust mask i f cutting operation is dusty
9. Dont Abuse Cord
Never carry tool by cord or yank i t to disconnect
from receptacie. Keep cord from heat, oll, and
sharp edges.
10. Secure Work
Use clamps or a vise to hold work. It's safer than
'sing your hand and i t fees both hands to operate
tool.
11. Don't Overreach
Keep proper footing and balance at all times.
12. Maintain Tools with Care
Keep tools sharp and clean for best and safest
performance. Follow instructions for lubricating
'and changing accessories
13. Disconnect Tools
14. Avoid Accidental Starting
Be sure switch is OFF when plugging in
Pago 5
Advertisement
