Advertisement
HANDLER
PROTECTION - IMPORTANT
1 . Never attempt to use a polishing motor without proper instruction.
2 . Never üne a polishing motor unless thø motor has been fitlød with polishing (splash)hoods or a similar
protective device containing a protective shield.
[Always use a dust collector when performing polishing or grinding operations.
4 . Rand and follow all instructions contained i n thie manual regarding "tol safety"
Handler manufactures a full ine of Chucks, Splash Hoods, Dust Collectors, and Protective Shields. Contact
us at the address below to request a Handler Catalogue.
CHUCK REMOVAL
'Alter finishing and completing a polishing or grinding operation, you may wish to
and change
tø another type of chuck o r accessory. This is completed as follow:
1 .
Turn the lathe off and allow the shat to come o a complete stop.
2 .
Using the chuck remover located on the lft ar right side ofthe lathe, pull upward on
the removers handle. This will push the remover outward, and push the chuck rom
the lathe shat, (See Figure 1. Page 1)
A few chucke may require the chuck remover to be rotated 350° before the chuck accessory is removed. Chucka
{ited to polishing motors containing 21/2" shatt ara removed by loosening the set screw which hole tn position,
3 .
To place anather chuck onto the lathe shat, follow the procedure listed on this page.
CARE AND MAINTENANCE
smove the chuck accessory |
ACCESSORIES
Handler manufactures a full ine of Chucks, Protective Hoods, Shields, nd Dust Collectors fr use with your
Red Wing motor. Handler chucks aro
p r e c i s i o n manufactured t o fit onto your Red Wing motor. A fow
of these
are described below.
The No. 7 L or R chuck l s made to accommodate butting whee!
and brushes for polishing acrylic dentures, plastics, and metals
'The threads contained an the tapered partion of the chucks frontal
surface secure the buff or brush i n position
ii)
Handler ST Jacobs type chucks are made to accommodate from
3 t p 1
ure and mandrels. Its manufactured for gros finishing
\
-
2
Advertisement
