Table of Contents
Advertisement
Appendix
Specifications
Television system
American TV standards
Channel coverage
VHF: 2 — 13
UHF: 14 — 69
Cable TV: 1 — 125
Microblack™ Trinitron® tube
27-inch picture measured
diagonatly
28-inch picture tube measured
diagonally
75-ohm external antenna terminal
for VHF/UHF
VIDEO 1 and 2 IN
S VIDEO IN (4-pin mini DIN)
Y: 1 Vp-p, 75-ohms
unbalanced, sync negative
C: 0.286 Vp-p (Burst signal),
75-ohms
Video (phono jacks): 1 Vp-p,
75-ohms unbalanced,
sync negative
Audio (phono jacks): 500 mVrms
(100% modulation)
Impedance: 47 kilohms
VIDEO 2 OUT
Video (phono jack):
75-ohms unbalanced,
sync negative
Audio (phono jacks):
impedance: 10 kilohms
AUDIO OUT (VARIABLE)
(phono jacks)
More than 408 mVrms at the
maximum volume setting
(variable)
Impedance: 5 kilohms
Speaker output
5Wx2
Power requirements 120 V AC, 60 Hz
Power consumption
Maximum:
165 W
Standby: 1.5 W
Dimensions (h/w/d)
595 x 683 x 573.5 mm
(23 V2 x 27 x 22% inch)
Supplied accessories
Remote commander RM-Y105 with
2 size AA (R6) EVEREADY batteries (1)
Antenna connector (1)
Terminal cover (1)
Recommended
accessories
U/V mixer EAC-66
Connecting cable
VMC-810/820S, YC-15V/30V
Video rack SU-27EX1
Design and specifications are subject to change without
notice.
Picture tube
Antenna
input
Output
Troubleshooting
Disturbances in picture and sound can often be
eliminated by checking the symptoms and following the
suggestions listed below.
SYMPTOM
CHECK AND ADJUST
Poor or no picture
(screen not lit), good
sound
e Adjust PICTURE.
¢ Adjust BRIGHT.
eCheck
antenna/cable
connections.
Good picture, nc sound
ePress VOLUME
+ on
the TV of VOL + on the
Remote Commander.
¢Press MUTING
on the
Remote Commander.
eCheck that the MTS
button is set correctly.
Check that the
TV/VIDEO
button is set
correctly.
eCheck that "SPEAKER
ON" is set.
eCheck that the speaker
cords are connected to
the SPEAKER
terminals.
No picture (screen not
lit), no sound
¢ Plug the unit into a wall
outlet.
eCheck that the
TV/VIDEO
button is set
correctly.
No color
els it a color program?
¢ Adjust COLOR.
els POWER
switched on? |
Snow and noise only
—______+
els it an active or the
correct channel?
eCheck the CABLE
setting.
eCheck antenna/cable
connections.
Py)
wt Sees cei] Dotted
This is often caused by
local interference. (e.g.
lines or
cars, neon signs,
=| stripes
hairdryers etc.) Adjust the
antenna for minimum
interference.
bs
Reflections from nearby
Double
mountains or buildings
images
often cause this problem.
or
A highly directional
ghosts
outdoor antenna or a
CATV cable may improve
the picture.
Try another channel. It could be station trouble.
If the problem persists, contact your nearest service
facility.
Appendix
| 3 9
Hujooysa
gy suonedyio
Advertisement
Table of Contents
