Sony Trinitron KV-27EXR90 Operating Instructions Manual page 10

Cnapter 1: set up
Connecting TV Antenna/Cable
You can use either an indoor or outdoor antenna with your TV.
We recommend using an outdoor antenna for better picture quality.
You can receive cable TV by connecting a cable supplied by your
local cable company.
75-ohm coaxial cable (round)
Check your antenna cable type and prepare the
end of the cable using the F-type connector.
Attach an &-type connector (not supplied).
wet
a == =
7mm (¥% inch) 10 mm (% inch) F-type connector
b ee
3mm (Ye inch)
c pyr
d a) 3)
Plug the connector into the VHF/UHF terminal at
the rear of the TV.
(Rear of TV)
VHF/UHF
* Most combination antennas are equipped with a signal splitter.
Remove the splitter and attach the appropriate connector.
8 Chapter 1: Set up
300-ohm twin-lead cable (flat)
Check your antenna cable type and prepare the
end of the cable using the 300-ohm twin-lead cable.
Attach the supplied antenna connector.
Loosen with a
screwdriver.
Attach the cable
and fasten with a
screwdriver.
Plug the connector into the VHF/UHF terminal at
the rear of the TV.
(Rear of TV)
GG.
VHF/UHF