Brewing Instructions - Curtis TPC15S10A1100 Service Manual

Milano single head coffee brewer
Table of Contents

Advertisement

Your Curtis Generation 3 System is Factory Pre‑Set for Optimum Performance.
After connection to water and power; the rear toggle switch must be on. You will hear a beep, indicating power is available to the UCM (Uni-
versal Control Module).
The control displays
After three seconds,
Water will fill the tank (approximately 2-3 minutes depending on water flow rate). When the proper level is reached
pear on the screen. It takes approximately 20 minutes to reach set point temperature of 200°F.
Control will display

BREWING INSTRUCTIONS

1. Brewer should be ON (Confirm at rear toggle switch, then press the ON/OFF button). Ready-to-Brew should read on the LCD screen. If con-
nected to an InterLock grinder, grinder should be on. Grind coffee at this time.
2. Place an empty Milano server under the brew cone.
3. Place a new paper filter
into the brewcone.
WARNING TO AVOID SCALDING, Do not remove brewcone while brew light is flashing.
Programming with the Universal Control Module (UCM)
Turn off the control panel by pressing ON/OFF button. Press and hold bottom/right coffee brew button (#4 in illustration) and then press and release the ON/OFF button.
Continue holding the bottom-right brew button. The screen will display
responds to the buttons illustrated below. The default code set at the factory is 1-2-3-4.
PROGRAM MENUS
After the 4-digit code is entered,
<
1
2
. Press ON/OFF button and the screen will display
is displayed.
when temperature reaches the set point (200°F); unit is at brewing temperature.
4. Fill the brew cone
with correct amount of
ground coffee.
PROGRAM MODE
will be displayed. You can now enter the program menu features.
SELECT
>
2
3
5. Slide the filled brew cone to
the brew rails.
ENTERING
ENTER CODE
, wait until
– – – –
All programming selections are performed with the three center buttons.
The symbols near the buttons are:
Scroll LEFT
 SELECTION or ENTER to save new parameter
Scroll RIGHT
4
.
6. Press the brew button to
start the brew cycle.
is displayed. Enter the 4-digit access code, the code cor-
will ap-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tpc2sTpc15s63a1100

Table of Contents