Remote Siren Silencing; Multiple Event Total Recall; Table Of Zones - Clifford GP1000T Installation Manual

remote siren silencing

While the siren is sounding, press the arm/disarm button once to silence the siren but
leave the system in the armed state. To disarm the system, press the arm/disarm but-
ton a second time.

multiple event total recall

This will report the last eight system triggers in reverse chronological order.
1. Press and hold
2. While still holding
3. The LED will start to flash to indicate the most recent trigger and proceed down to
the eighth trigger. For more information, please refer to the Table of Zones section
of this guide.

table of zones

When using the diagnostic functions, use the Table of Zones to see which input has
triggered the system or was active during arming. It is also helpful in deciding which
input to use when connecting optional sensors and switches. Zone reporting occurs
when the system is disarmed and the ignition is turned on. The LED displays the last
zone triggered 5 times.
N N O O T T E E : : The Warning Zone response does not report on the LED.
LED Flashes Trigger type
1 Tilt Sensor
2 Mux 1
3 Mux 2
4 Instant
5 Instant
6 Instant
7 None
© 2005 directed electronics, inc.
of the Valet switch.
, arm and disarm the system, then release the button.
Input description
Built-in Tilt Sensor
Mux 1 sensor input (BLUE wire)
Mux 2 sensor input (ORANGE wire)
Normally Closed input (from protective switch)
Normally Open/Closed programmable input
Ignition Input
12 V Power interruptions
19