Table of Contents
Advertisement
20
Heat the 2 microwaveable heating bags for 40-60 seconds in a 700 W microwave and
apply them at the front upper left edge of the screen for 1 minute.
Follow the heating bag's instructions for heating. The recommended time for
•
heating the bag is 50 seconds in a 1000 W microwave and 70 seconds in a 700 W
microwave. (Correct temperature for use: 55-65 ℃.)
Be careful not to damage the device through excessive heat. (It is
•
recommended to disassemble the device in an area with a temperature gauge.)
21
While applying the 2 heating bags under the back of device, place the suction cup (L)
in the top left edge of the screen, lift upwards carefully, and then insert the opening
tool (L) in the gap.
As the internal circuitry can be damaged, do not insert the opening pick more
•
than 2 cm.
As the screen can be damaged by excessive force, be careful not to damage the
•
screen.
Be careful that the suction cup does not adhere to the area where the tape or
•
sticker is attached.
If you have trouble creating a gap, heat the microwaveable heating bag
additionally, and apply it on the screen to further soften the adhesive. When
reheating, it should be heated no longer than 40-60 seconds.
Disassembly and Assembly
78
Advertisement
Table of Contents
