Troubleshooting - Pioneer LASER DISC CLD-990 Operating Instructions Manual

Cd cdv ld player
Table of Contents

Advertisement

TROUBLESHOOTING
SYMPTOM
CAUSE
REMEDY
5. Disc is rotating but there is no
picture.
The TV set is not turned on.
Wrong connections from player to TV.
Turn on TV.
Make correct connections.
6. Picture
continuously
moves
vertically.
4+.
The TV vertical hold control is not adjusted
properly.
Adjust vertical-hold control on TV.
7. Particular
disc
does
not
playback
properly.
The
playback stops in the middle
of the disc program.
8. Sound
is
distorted.
9. No
sound
output
during
playback.
unnatural
or
The playing surface of the disc is dirty.
The disc is warped.
CX system is turned ON for disc which has
no Da mark.
MULTL-SPEED
or STILL/STEP playback is
being performed.
Sound
is output only
during the normal play mode. The audio
signals are not output during other playback
modes.
@
Press D/AYCX to turn CX system OFF.
Use a soft colth and lightly wipe off the dirt
from the surface of the disc. If necessary,
moisten a cloth with diluted neutral detergent
to remove heavy dirt of fingerprints.
LD discs only
Put the disc into the protective envelope, then
place it on a flat desk top. Subsequently, place
a flat board e.g. glass plate on the disc, and
load it with about 4 ~ 5 kgs {about 10 Ibs), If it
is left in this state for one day, sometimes the
warp will alleviated.
Heavy books
about 4 ~ 5 Kgs
(10 tbs)
LD disc-—_—
ZS
Glass plate
Glass plate
Protective
envelope
Press PLAY or PLAY/PAUSE to set the player
to normal play mode.
40. During STILL playback, a part
of the screen image shakes.
Even if the disc is a standard play disc, there
may be some cases in which a fully still image
cannot be obtained, but this does not mean
that the player or the disc is defective.
11, CHAPTER
SKIP, CHAPTER
PROGRAM
PLAY
and
CHAPTER NUMBER SEARCH
cannot be performed.
Disc in which
no chapter numbers
are
recorded is loaded.
Press DISP to check if chapter number
is
displayed.
12, Certain discs take too long to
search for or do not search
for.
It takes time to read the recorded code,
depending on the disc.
Press CLEAR and picture will appear.
{At this point, a slightly different scene from
that which has been searched
for may
appear.}
25
<VRB1059>

Advertisement

Table of Contents
loading

Table of Contents