Pioneer CT-W505R Operating Instructions Manual page 3

Sear eh
This equipment has been tested and found to comply with the limits for e Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection sgainst harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, i not instelled and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
~Reorient of relocate the receiving antenna.
~ increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
~ Consult the dealer or an experienced radio/TV technician for help.
L
Information to User
Alteration or modifications carried out without appropriate authorization may invalidate the user's right to operate the equipment.
1, Disconnect the power cord.
2. Use a screwdriver with a tip
that fits neatly in the groove.
3, insert the screwdriver into
the groove on the voltage
selector and adjust accord-
ing to the voitage value of
your area.
VOLTAGE SELECTOR
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this switch. U.S.,
U.K., and Australian models are not provided with this switch.
Main vottages in Saudi Arabia are 127 V and 220 V only. Never
use this model with 110 V setting in Saudi Arabia,
Check that it is set properly before plugging the power cord into the
wall outlet
&
MAINTENANCE
NOTE:
After cieaning the head section, do not load a tape until the cleaning
Capstan AS is fluid has dried completely (about two or three minutes).
E id
reee fee
[ DEMAGNETIZING THE HEADS
Pinch roller
Capstan
Rec/play head
Pinch roller
[CLEANING THE FRONT PANEL
The heads, pinch rollers and capstans are likely to get dirty quite
easily. If these parts, particularly the heads, get dirty, the high fre-
Quency components of a recording will not be reproduced and the
stereo balance wili be impaired, resulting in a deterioration of the
playback sound. It is therefore recommended that the head section
be cleaned regularly,
. Set the POWER switch to STANDBY.
. Press the eject button to open the cassette door.
. Dip a cleaning swab in cleaning fluid and use it to wipe the heads,
capstans and pinch rollers.
3
<RRB1170>
En
wna