Table of Contents
Advertisement
@ How to retrieve memorized stations
(@) Press the Classified Memory button for the desired class. It
remote control is used, the class next to the present one is
retrieved when the CLASS button is pressed.
@ The memory number (station) which was being received
before the olass is retrieved will be received.
(2) There are several methods to proceed after the above opera-
tions are carried out. Use any of the following methods.
a. Pressing the same Classified Memory button again per-
mits the nex! preset memory number (station) to be*
received.
'b, Input the memory number you wish to receive by using the
Number buttons.
@ ifthe memory number consists of 2 digits, input two num
bers, immediately one after the other. For instance, when
inputting "15", "15" will not be registered if you wait more
than one second before inputting "5", resulting in only "1
being registered.
© if a number other than a number trom 1 to 40, or a number
which has not been memorized 's input, the number
flashes for 2 seconds and then the number which was dis
played before will be displayed.
© Ita number between t and 4 Is pressed, the display and
station are changed 1 second later,
©. Press the CLASSIFIED SCAN button
@ Stations memorized in the present ciass will be scanned
in a order and the corresponding memory number will
flash in the Preset station display at each scan. After the
iast memory number of the class is reached, scanning
starts again from the first memory number of the class,
Pressing the CLASSIFIED SCAN button again stops
scanning.
d. When the PRESET UP or COWN button of the remote
controller is pressed, the memory number of the class cur-
rently being received will be incremented or decremented.
Keeping pressing the button increments or decrements
continuously. After the maximum or minimum number is
reached, the next class or one before the present class
will be entered.
Tape Recording
With the TX-SV515PRO you can pertorm recording while listening to the sound of another source through speakers or headphones; Make all
connections between the tape deck and the unit as shown in the System Connections diagram,
@ When recording a tape while the multiple room remote control is connected, turn on ITFR OFF (the MR OFF indicator will light) to disable
remote control operation from other rooms.
™ Recording and dubbing to a tape deck connected to TAPE-1
(When recording the source you are listening to)
(@@) REc out
Source required
Source selected in (1)
@ Starting tape
@ Starting
deck recording
Bouts selected
in ( 1 )
@pr ress ine input selector bution to select the source to be
recorded. (Other than TAPE-1)
Op
ress the REC OUT button.
on the display flashes for 8 seconds.
® Press the REC OUT button again while the [REC OUT Indica-
tor is Hashing
Os
REC OUT)
and [SOURCE] will light, and the indication of
the
source
selected
by the Input selector button
will be
marked with a red frame.
tart the device selected in stop (i), while setting the tape deck
connected fo TAPE-1 to recording mode.
Set the proper recording level using the controls on the tape
deck used for recording. Never change the positions of any
controls (bass, treble, etc.) on this unit during recording and
dubbing operations.
NOTES:
Pressing the \nput selector button during recording will
change the source being recorded,
When the TAPE-2 MONITOR indicator is on, only TAPE-2
can be recorded and if the input selector is changed, the red
frame of TAPE-2 will not change.
Advertisement
Table of Contents
