Table of Contents
Advertisement
Video Disc Player (or Video Cassette Player) Connections
(VIDEO-1)
Connect the VIDEO outpul of the video disc player to the TX-
SV515PRO (VIDEO) VIDEO.1 "IN" jack and the AUDIO output to the
(AUDIO) VIDEO-1 "IN" jack. The VIDEO-1 jack is only for playback,
there is no OUT jack. For more details, reler to the video disc player
instruction manual.
Video Cassette Recorder Connections (VIDEO-2, 3)
4. Connect the VIDEO output of the VCR to the rear panel (VIDEO)
VIDEO-2, 3 "IN" jack and the VIDEO input of the VCR to the rear
panel (VIDEO) VIDEO-2, 3 "OUT" jack. Then connect the AUDIO
'output of the VCR to the (AUDIO) VIDEO-2, 3 L and R "IN" jacks.
Finally, connect the AUDIO input of the VCR to the (AUDIO)
VIDEO-2, 3 L and R "OUT*jecks.
When using a playback-only VCR, only the output connections
need to be performed.
For more details, refer to the VCR instruction manual
TV Connections (MONITOR)
1. Connect the TV VIDEO input to the TX-SV515PRO "MONITOR
OUT". jack. There is no need to perform an audio connection
since sound will be sent directly from the TX-SV51SPRO to the
speaker systems.
The TX-SV515PRO does not have an RF converter. Therefore, it
can be used with only a monitor TV equipped with a video input
jack.
'Since the television set, tuner (FM/AM) section of this unit can
cause interference that may disrupt sound andlor picture quality,
the TV and TX-SV515PRO and their respective connection
cables should be placed as far apart as possible. The use of a
common TV/FM antenna is not recommended (see antenna sec-
tion).
2
3.
AC Outlets
@ SWITCHED:
These outlets are switched on and off by the Power button on the
front panel and remote control transmitter. Capacity is total 120
watts.
Connections for Remote Control (REMOTE CONTROL)
© A cassette tape deck, and compact disc player that have the
ONKYO FRI mark can be operated using the accessory remote
control transmitter with the TX-SV515PRO.
TXSVS15PRO
Ri acwort
conrad
compact
DISC PLAYER
RI piwore
conto
REMOTE CONTROL
CASSETTE
TAPE DECK
I mary
Connect a remote contro! cable to the
Diack jack win the FRE mark
'An RE romote control cable equipped with a 1/8" (3.6m) damator miniature
tworconductor phone plug Is atiached 10 the TX-SV51SPRO end to CD player,
with the FRE mark,
To use an ONKYO compact disc player and cassette tape deck with
the RU mark, insert the accessory remote control cable plug into
the REMOTE CONTROL jack. As far as connecting sequence is
concerned, it doesn't matter whather the cable is connected from the
TX-SV51SPRO to the cassette tape deck or to the compact disc
player, The remote control transmitter is operated by facing it
towards the remote control sensor of the TK-SV515PRO.
NOTES:
@ To enable remote contiol operation, the audio connection
cables and the remote control cable should be connected
between the units
@ The remote control of the TX-SV515PRO cannot be used to
operate an ONKYO turntable:
Advertisement
Table of Contents
