Table of Contents
Advertisement
Listening to devices connected to
the TX-SV515PRO in another room
@
TX-SV515PRO allows you to listen to the desired performance in another room (sub room) while listening to the playback of a device located
in the main room. To do this, connect the speakers in another room to the FRONT SPEAKERS REMOTE terminals on the TX-SV515PRO,
@ Remote control from another room can be done by employing the ONKYO multiple room remote system (412). Refer to the connections for
multiple room remote control, Be sure to operate the remote control unit directing to the remote sensor unit HR-10,
© The following steps (except step (1) ) can be performad using the ramote control unit. It is recommended that the adjustments described
below be done in the main room in advance, sinc
play of the TX-SV5152RO.
(@ MR OFF
@) MULTI SOURCE
= 'o) Source required
® Speaker Selector
REMOTE
(@) MULTI SOURCE
UP/DOWN
NOTES:
@ The surround mode will be turned OFF (Bypass) when
MULT! SOURCE is used.
© The source indicated by the input selector will be output from
the TAPE-! and 2, and VIDEO-2 and 3 REG OUT terminals.
© Press the REC OUT button to change the MULT] SOURCE
mode to the Surround mode or REG QUT selector modes.
is not possible to operate the remote control unit in another room while watching the dis-
Make sure that recording is not being carried out before setting the
TX-SV51SPRO.
() Turn the MR OFF button OFF ( IMR indicator is tured off.)
@) Press the MULT] SOURCE bution,
©
[REC OUT indicator will be turned off and the
indicator will flash for 8 seconds
@ While
this is flashing, use the input selector button to select the
desired source.
e
will light and the selected source will be
marked with a red frame.
© If tuner is selected with MULT! SOURCE and the input selec-
tor is set to something other than TUNER, the tuner's fre-
queney and class displays will be shown for 5 seconds.
During this time a tuner preset station can be selected.
@ Adjust the level using the MULTI SOURCE UP/DOWN buttons of
the remote control transmitter.
© MULTI and the level will be indicated on the display. It is
recommended that the Jevel be set lower in advance in the
main room (~78 16 -76d8),
@ Press the REMOTE button of the SPEAKERS to illuminate the
REMOTE] indicator.
© Press the MAIN button to turn off the [MAIN] Indicator if you
ate not listening the sound in the main room
When changing the source, be sure to press the MULTI
SOURCE button before pressing the input selector button.
Pressing the input selector button without first pressing the
MULTI SOURCE button will change the source in the main room.
MR Off button (MR OFF) and indicator
Use this button for tape recording or for the surround sound
modes.
It is used to disable control of the ONKYO MR system
via the remote control unit in another room. Pressing this button
'will iIluminate the indicator, and control from another room will be
disabled, Pressing the button again will turn the indicator off, and
'control from another room will be enabled,
NOTES:
© If the multi source is selected, the MR OFF automatically
turned OFF.
© It the multi source is selected for REC OUT, and the SUR-
ROUND MODE key is selected, the MR OFF automatically
turned OFF.
@ You can use the remote control. transmitter supplied with this
'Tuner Amplifier to operate the source devices selected for the
multi source if they are an ONKYO CD or cassette deck bearing
the RI mark,
@ There is a remote control unit RC-MA1H for the sub room, which
is sold separately.
@ Installment of the remote sensor unit HR-10 and te remote
'emitter unit HE-50(AC) Is required to control non-ONKYO.
devices from another room (sub room). Operate the remote con-
tro! unit included with the device by directing the control unit
toward the HR-10 installed in another room (sub room).
@ It @ problem occurs, use the TX-SV515PRO's tront panel con-
trols to verify that the problem is with the remote controller.
It there is no problem when operating the TX-SV51SPRO.
directly, check the batteries in the remote controller first bofore
assuming that there 1s a controller malfunciton.
NOTES:
@ The source may be changed or recording being done on the
TX-SV515PRO may be interrupted when operations are done:
in the another room, Press the MR Off button to disable the
control from another room, (The MR indicator will be illumi-
nated.)
@ Some non-ONKYO remote contro! transmitters cannot be
used.
-17-
Advertisement
Table of Contents
