Table of Contents
Advertisement
3. Wiring Information
The FDL242 contains software that processes the output of the detector and generates a Fire and Fault status. This status is transmitted to the
Siemens Fire Control Panel (FCP) over FDnet/C-NET which also powers the FDL242. To wire a detector to a FCP , use the following wiring
diagram. NOTICE: Install one cable ferrite 4 on each cable entry to the detector.
Use of Unshielded Cables
The connection is established from base to base using twisted or non-twisted wire pairs.
1
Control Panel
2
Detector
3
Auxiliary Terminals DBZ1190-xx
4
Cable Ferrite
Page 5
Advertisement
Table of Contents
