Table of Contents
Advertisement
If the left-hand green LED flashes, the signal is larger and the detector is moving closer to the reflector.
a
The next movement must be in the same direction. Keep moving the detector, waiting for the LED flash each time.
If the left-hand green LED keeps flashing, keep going in the same direction.
If the amber and the green LED flashes, then move onto the other axis (see step (4) below).
If the amber LED flashes, move back in the opposite direction once, then move onto the other axis (see step (4) below).
4. 4.
6. Follow the same process as in step (3), this time in the left-right axis. Start by moving in the left direction.
5.
7. Once the alignment has been completed on both axes move the Alignment switch (1) to the left-hand position ("Auto").
The right-hand green LED will flash for 10s.
a
The Detector can be tested to ensure it is operating and connected to the Siemens Fire Control Panel correctly.
To activate the test alarm, see chapter 8 Status Indications and Troubleshooting, ' A ctivating the test alarm'.
Page 19
Advertisement
Table of Contents
