Table of Contents
Advertisement
1. Install the mounting bracket.
•
M6x60 expansion bolts are delivered with the inverter. If the length and number of the bolts
do not meet installation requirements, prepare M6 stainless steel expansion bolts by yourself.
•
The expansion bolts delivered with the inverter are used for solid concrete walls. For other
types of walls, prepare bolts by yourself and ensure that the wall meets the load bearing
requirements of the inverter.
•
Loosen the nuts, flat washers, and spring washers of the two expansion bolts.
Level
2. (Optional) Install the screw for locking the DC switch.
•
The screws for DC switches are delivered with solar inverters. According to Australian
standards, the screws are used to secure DC switches (DC SWITCH) to prevent them from
being turned on by mistake.
•
For the model used in Australia, perform this step to meet the local standards.
3. Install the inverter on the mounting bracket.
Prepare an anti-theft lock suitable for the lock hole diameter (Ф8 mm) and ensure that the lock
can be installed successfully. An outdoor waterproof lock is recommended.
4. (Optional) Install an anti-theft lock.
3
Advertisement
Table of Contents
