KitchenAid KDC-21AD Use & Care Manual page 23

Table of Contents

Advertisement

The 4-Way Hydro Sweep Wash
Arm, the removable filter and the
coarse strainer may be removed
and cleaned if necessary. If food
soils remain on the removable filter,
lift the 4-Way Hydro Sweep Wash
Arm straight up. Check underside
of wash arm to make sure the
opening of the single stainless steel
spray nozzle (D) and the nine water
jets (E) are not blocked. Next, re-
move the removable filter, by lifting
the filter straight up and out. TO
CLEAN, scrub filter with a stiff
brush under running water. TO RE-
PLACE, snap removable filter over
the ultrafine filter and then replace
the wash arm. When replacing
wash arm, be sure that water jets
on the wash arm are facing up.
The coarse strainer may be re-
moved if necessary. TO REMOVE,
lift strainer out by squeezing center
section (F) and remove. TO RE-
PLACE, squeeze center section so
clips snap into square notch.
The Overflow Protection Float (G)
in the front left corner of the dish-
washer tank prevents the dish-
washer from overflowing. The float
must be in place for the dishwasher
to operate.
NOTE: A small amount of water al-
ways remains in the sump (under
the ultrafine filter) to lubricate the
seal.
23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kudc21d

Table of Contents