Gps tracker with data logging backlit lcd display long battery life fits in the palm of your hand water resistant for outdoor use shared bluetooth wireless connectivity (20 pages)
Table of Contents Table of Contents Introduction What’s in the Box? Product Overview Charging and Charge Management Charging your Bad Elf Flex Mini Operation while charging Temperature limitations Low battery Battery Safety Basics of Operation Powering On and Off Using Your Bad Elf Flex Mini...
Introduction Thank you for purchasing a Bad Elf Flex® Mini GNSS receiver. This manual describes the basic operation of your Bad Elf Flex Mini as well as specifications and warranty information. For the most recent information, visit bad-elf.com/flex-mini. What’s in the Box? The following items are included in the standard Bad Elf Flex Mini configuration: ●...
4hrs. Operation while charging You can operate your Bad Elf Flex Mini while it is charging. A charge current of 500mA or greater can sustain unlimited operation regardless of the charge state.
Basics of Operation Powering On and Off To turn the Bad Elf Flex Mini on, press and hold the power button for 3 seconds. It will take approximately 5 seconds to start up and to begin searching for satellites. To turn the Bad Elf Flex Mini off, press and hold the power button for approximately 3 seconds until the display turns off.
None No Bluetooth connection found Buttons The buttons on the left and right side of the Bad Elf Flex Mini allow you to navigate the LCD screens and menus. Descriptions for each button are provided in the table below. Button...
Supported Platforms You can connect a Bad Elf Flex Mini to a phone, tablet, or PC powered by the following operating systems: ● iOS version 11 or newer (see model list below) ● Android version 4.1x or newer ● Windows version 10.x or newer ●...
Bad Elf Flex Mini. 6. Once paired, you will see the Bad Elf Flex Mini appear in the list as Connected for a few seconds then return to Disconnected. This is normal. The Bluetooth connection will be established whenever an app requests it.
3. If your Bad Elf Flex Mini is turned on, you should see it appear in the list as something like Bad Elf Flex Mini #XXXXXX (with its serial number). 4. Select your Bad Elf Flex Mini from the list, and tap the Pair button.
Commission rules. Human exposure to radio frequency energy Like any other mobile device, the Bad Elf Flex Mini emits radio frequency energy (RF) during use. According to the International Commission on Non-Ionizing Radiation Protection (ICNIRP), the critical effect of RF exposure relevant to human health and safety is heating of exposed tissue.
You can find additional information about SAR at the following pages: http://fcc.gov http://icnirp.org http://ec.europa.eu Bad Elf Flex Mini has been tested and certified to not exceed SAR limits in the U.S., Canada, European Union, or Australia. Limited Warranty Terms and Conditions Warranty...
Online Auction Purchases: Products purchased through online auctions (that means purchases not made through bad-elf.com, on eBay from bad-elf-llc, on Amazon from Bad Elf, LLC, or an approved reseller) are not eligible for warranty coverage. Online auction confirmations are not accepted for warranty verification.
BAD ELF’S ENTIRE LIABILITY UNDER ANY PROVISION HEREIN SHALL BE LIMITED TO THE AMOUNT PAID BY YOU FOR THE PRODUCT. TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, IN NO EVENT SHALL BAD ELF OR ITS SUPPLIERS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGE...
Need help?
Do you have a question about the Flex Mini and is the answer not in the manual?
Questions and answers