Haier HLF11PC User Manual page 16

E LE C TR i CAL R EQ U !RE ME hiTS
E_ectr_¢a| Shock Ha_rd
P_ug _nto _ g_oended 4 prong cut,eL
F_ure _ do so _a_ res_| _ d_|h _r
e_ec_Jca] shock,
it is your responsibility
• To contact a qualified electrical installer.
To be sure that the electrical connection is
adequate and in conformance with CAN 1-
B149 (.1 or .2)installation codes and/or
local codes.
A 4 wore. somg;e Base. 115/230-volt. 60 Hz.,
AC-only electrical supply is required on a sepa-
rate 30-amp circuit, fused on both sides of the
line. A time-delay fuse or circuit breaker is
recommended. Connect to an individual
branch circuit.
This dryer is equipped with a CSA International
Certified Power Cord intended to be plugged
into a standard 14-30R wall recepatacle. The
cord is 5ft (1.52) in length. Be sure wall
receptacle is within reach of dryer's final
location.
4-Wire receptacle 14-30R
if using a replacement power supply cord, it is
recommended that you use Power Supply Cord
Replacement. For further information, please
reference the service numbers located in the
"Assistance or Service" section of this manual.
Replacement Power Supply Cord must be:
UI listed or CSA International Certified
Marked for use with Clothes dryer.
• Rated 115/230 volt minimum
30 amp
Type SRD or SRDT
• 4 conductors
• At least 5 ft (1.52m) long
GROUNDING INSTRUCTIONS
For a grounded, cord-connected dryer:
This dryer must be grounded. In the event of
malfunction or breakdown, grounding will
reduce the risk of electric current. This dryer is
equipped with a cord having an equipment
grounding conductor and a grounding plug.
The plug must be plugged into an appropriate
outlet that is properly installed and grounded in
accordance with all local codes and ordiances.
tVARNING:
Improper connection of the
equipment grounding conductor can result in a
risk of electric shock. Check with a qualified
electrician or service representative or personnel
if you are in doubt as to whether the dryer is
properly grouded. Do not modify the plug pro-
vided with the dryer: if if will not fit the outlet,
have a proper outlet installed byu a qualified
electrician.
SAVE THESE iNSTRUCTiONS
15