Advertisement
NOTE: This procedure will not show proper lower
• If the guard immediately springs back into place,
it is working correctly and you may continue with
• If the guard does not immediate spring back into
place, clean the upper and lower guards to remove
• If the guard still does not immediately spring back
into place, contact a MILWAUKEE service facility
Installing and Removing Blades
spindle lock button, use the wrench provided with
clean the spindle, upper guard and lower guard to
NOTE:
Spindle
the teeth pointing in the same direction as the arrow
Adjusting Depth
the cut, hold the saw
by the handle and
loosen the depth ad-
pushing it up to-
wards the motor
ments are located on the inner side of the upper
1/4" 6mm
-
-
the handle to the desired angle as indicated by the
Adjusting the Blade to Shoe
square against the blade and shoe to inspect the
Bolt
WARNING
to comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
-
ing parts.
or removing accessories. Only use accessories
– Kickback is a sudden reaction to a pinched, bound
or misaligned saw blade, causing an uncontrolled
saw to lift up and out of the workpiece toward the
operator;
5
Adjusting Bevel Angle
OPERATION
To reduce the risk of injury, always
wear proper eye protection marked
-
Bevel
adjustment
screw
-
-
Advertisement
