Advertisement
GTx
LED Arrow Signals
™
Installation Steps
Verify input voltage is within specified range on the back of the LED signal module before installation. Failure to do so
1
will cause lamp to fail.
2
Open front cover of (customer supplied) traffic signal housing.
3
Remove outer lens and incandescent bulb from traffic signal housing OR existing LED signal module. Retain all hardware
as removed as it may be needed in subsequent steps.
NOTE: Installer is responsible for ensuring the disposal of removed components complies with all applicable regulatory
requirements.
Ensure that a gasket is present around the perimeter of the new LED signal module.
4
Insert the LED signal module into the available cavity from previous LED module or incandescent bulb.
5
NOTE: Ensure that the arrow on the back cover of the LED signal module is oriented in the desired position.
6
Install mounting hardware to ensure that the LED signal module is securely fastened to traffic signal housing.
Connect the white wire to the neutral terminal block and the colored wire to the positive, supply voltage terminal block.
7
NOTE: Ensure that the correct wire is securely connected to correct terminal block for proper operation.
8
After installation of all modules is complete, ensure all traffic signal housings are closed and secured properly.
9
Apply power and ensure proper operation of traffic signal modules per intersection requirements as specified by
customer.
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are trademarks
of the General Electric Company and are used under license. Information and specifications subject to
change without notice. All values are design or typical values when measured under laboratory conditions.
Arrow
"Suitable for mounting in
any orientation"
Installation Guide
CAUTION
RISK OF ELECTRIC SHOCK
Install unit in enclosure
tested to be suitable for wet
locations only.
TRAF324-GTX-LED-Arrow-Signals-12-inch-lnstallation-Guide
Page 2 of 2
(Rev 06/21/23)
Advertisement
