Century EB-4 Owner's Manual page 45

Section IVA- OPERATING INSTRUCTIONS
4A.4 VEHICLE HOOK UP (cont'd)
(d) If necessary, disengage plunger pin and adjust tire restraint until
it is as close as possible to rear of tire. Ensure that plunger pin
fully re-engages in tire restraint arm. See Figure 4A.8.
WITH TIRE RESTRAINTS INSTALLED, BE CERTAIN THAT IT
WILL CAUSE NO DAMAGE TO THE VEHICLE TO BE TOWED
WHEN WHEEL LIFT IS IN ITS RAISED POSITION. TO AVOID
ANY DAMAGE FROM TIRE RESTRAINTS, ADJUST
CROSSTUBES TO DESIRED POSITION.
(e) Repeat procedures (a) through (d) on opposite side.
(f) Using the BOOM "UP-DOWN" Control, raise vehicle to desired
height. See Figure 4A.9.
WHEEL LIFT (cont'd)
FIGURE 4A.8
NOTE
IVA-7