jcb 525-60 Operator's Manual page 25

ROPS Data Plate
WARNING Your machine may be fitted with a Roll-Over Protective Structure (ROPS) indicating that the
purchaser specified the machine for use in applications where there is risk of roll-over. ROPS is a device
to protect the operator in the event of roll-over. Any damage or modification to the structure may invalidate
the ROPS certification. If damage has occurred then an authorised JCB dealer should be consulted.
A machine with a ROPS (Roll-Over Protective Structure) can be identified by referring to the cab identification
plate. Work place (work site, job site) risk assessment should facilitate the machine selection and the need
for an machine with a ROPS.
Data plate - ROPS/FOPS standards
The mass shown in these data plate are a test mass and the maximum operating mass of this machine may
be lower.
14
Product and Component Identification
Figure 10.
9821/9100-5
About the Product
14