Positioning The Seat - Toro 74675 Operator's Manual

Testing the Safety-Interlock System
1. Sit in the seat with the engine off and ensure that the
PTO switch is in the
2. Turn the ignition key to the
should crank. Do not start or shut off the engine prior
to step 3.
3. Turn the key to the
Park switch to the
OFF
disengage and the brake light should turn off.
4. With the brake disengaged and traction pedal in the
position, turn the ignition switch to the
NEUTRAL
position. The brake should automatically
START
engage, the engine should crank, and the brake light
should turn on.
5. With the engine off and the key in the
engage the PTO by pulling up the blade-control switch;
you should hear the clutch engage.
6. Ensure that the traction pedal is in neutral and turn
the ignition switch to the
should disengage and the engine should crank and start
without the blades moving.
7. With the engine running, rise from the seat. The engine
should remain running and the brake light should be
on.
8. Return to the seat and disengage the parking brake by
pushing the Smart Park switch to the
The engine should continue to run.
9. Rise from the seat again. The brake should
automatically engage and the engine should continue
to run.
10. Return to the seat and engage the blades by pulling up
the blade-control switch.
11. Rise from the seat. The blades should disengage and
the engine should continue to run.
12. Return to the seat and pull up the blade-control switch.
The blades should engage. Disengage the blades by
pushing down the blade-control switch.
13. Pull up the blade-control switch to engage the blades.
Move the traction pedal to the
blades should disengage. Move the traction pedal to
the position.
NEUTRAL
14. Pull up the blade-control switch to engage the blades.
Turn the Key Choice switch to the
and release it. The operating-in-reverse light should
illuminate.
15. Move the traction pedal to the
The blades should remain engaged. Push the
blade-control switch in to disengage the blades. The
operating-in-reverse light should turn off. Move the
traction pedal to the
16. If not engaged, push the SmarkPark switch to the
position and lightly tap the traction pedal in the either
position.
OFF
position; the starter
START
position and push the Smart
ON
position. The brake should
position,
ON
position. The PTO
START
position.
OFF
position. The
REVERSE
position
ON
position.
REVERSE
position.
NEUTRAL
the
FORWARD
disengage and the brake light should turn off.
Note: Tap the pedal, do not fully engage the pedal as
that causes the brake system to bind and not release.
17. With the brake released, engage the traction pedal
slightly and rise from the seat. The engine should shut
off.
18. Return to the seat and turn the ignition key to the
position. After several seconds, the brake system
OFF
should engage.
Note: With the key in the
does not illuminate.

Positioning the Seat

A
C
ON
17
or position. The brake should
REVERSE
position, the brake light
OFF
B
Figure 11
g027249
g027249