Table of Contents
Advertisement
Connecting the TV to a SBB or STB
STB (SBB)
ETH MODEM
Connect the DATA port of the TV to the ETH MODEM port of the STB (SBB) with the Data cable.
• The ETH MODEM port name that you connect the Data Cable to may differ depending on the SBB or STB type.
• IR signals sent by the remote control to the TV or SBB / STB must meet the following specification to use IR pass
through function.
IR signal receiver specification
– Band pass filter centre frequency: 37.9 ㎑
– Carrier Frequency, Duty 50%
– Minimum Burst Length (tburst): 12 pulses (316 us)
– Minimum Gap Time Between the burst (tburst gap): 16 pulses (422 us)
– Minimum Gap Time between the data commands (tpause): 25 ㎳
List of Hospitality SI Vendors and compatible data cables supplied with the TV
• Confirm you are using the correct data cable for your SI vendor. Refer to the code label on the data cables.
• Contact your nearest dealer or your SI Vendor to buy the data cable not included in the TV.
TV side
5
4
3
2
1
Cable code
BN39-02462A
(Colour: BLACK)
• RX and TX notation is based on TV.
• Operation Specification of Data Cable(RJ12): RS232
Confirm the code on the Code Label.
TV SIDE
1: TX
2: RX
3: IR
4: NC
5: GND
English - 27
Data Cable
Pin assign
P1
P2
STB (SBB) SIDE
RED
1
3
GREEN
2
5
WHITE
3
6
BLACK
4
1
YELLOW
5
2
TV Rear Panel
STB (SBB) side
1
6
REMARK
1: NC
SAMSUNG and
2: GND
3: TX
4: NC
others
5: RX
6: IR
Advertisement
Table of Contents
