Toyostove Laser 56 Type I Installation And Operation Instructions Manual page 15

Should problems arise during operation or ignition, use this chart to determine the cause and the proper
steps to take. Be sure to unplug heater and allow to cool completely before taking corrective measures.
In the event that heater should extinguish itself, without any action or your part, you should look to the digi -
tal indicator for any of the following error codes.
DISPLAY/LAMP PROBLEM
POWER LAMP
FAILS TO TURN ON
EE2 NO IGNITION*
EE2
EE2
EE2
EE2
EE2
EE8
EE6 EXTINGUISHED
AFTER IGNITION
EE6
EE6
EE6
EE6
EE6
EE6
EE8
POOR COMBUSTION/
NOISY COMBUSTION
DOES NOT
EE10
EXTINGUISH
ODOR
Hi
Lo
DOES NOT
Low/Med/
EXTINGUISH
High lamps
flashing at
the same
time
WARNING: Do not re-use the unit until the cause of the "EE10" code has been determined.
If the corrective measures outlined above do not solve the problem, please consult your TOYOSTOVE dealer.
*Note: If the unit fails 3 times after checking all causes listed, DO NOT CONTINUE turning the power switch
on and off. (Consult your dealer.)
CAUSE
Disconnected power plug
Circuit board malfunction
Out of fuel
Fuel tank valve closed
Air pocket in fuel line
Clogged flue pipe
Clogged fuel strainer
Igniter, circuit board, flame
sensor or fuel pump malfunction
Blower motor malfunction
Air pocket in fuel line
Out of fuel
High limit switch activated
Fuel flow obstruction
Tank too high
Fuel sump valve malfunction
Flame sensor malfunction
Blower motor malfunction
Soot buildup in flue pipe
Burner ring not properly seated
Altitude too high (See page 23.)
Possibly excess fuel in burner
Flame sensor malfunction
Leaking flue pipe
Kerosene leakage
Faulty packing or gasket in
combustion area
Room temp is over 95˚F.
Incorrect location of room temp
sensor
Room temp is lower than 14˚F.
Room temp sensor malfunction or
disconnected
Possibly excess fuel in the burner or
flame sensor
malfunction (miss detection)
SOLUTION
Plug into 120V AC outlet.
Consult your dealer.
Check fuel gauge on fuel tank; refuel.
Open valve by turning counterclockwise.
Push reset button on the fuel sump,
located right inside, once.
Clean flue pipe.
Clean fuel strainer (See page 13).
Consult your dealer.
Consult your dealer.
Push reset button on the fuel sump,
located right inside, once.
Check fuel gauge on fuel tank; refuel.
Clean circulation fan cover, remove any
obstructions.
Consult your dealer.
Re-locate fuel tank.
Consult your dealer.
Consult your dealer
Consult your dealer.
Clean out any soot.
Consult your dealer.
Consult your dealer.
Consult your dealer.
Consult your dealer.
Tighten all flue pipe connections.
Tighten all fuel line joints. Wipe away any
kerosene drippage.
Consult your dealer.
Correct the location of the room temp
sensor.
Check room temp sensor.
Consult your dealer.
15