Advertisement
5. PRECAUTIONS
FOR
REASSEMBLY
Follow these directions
and precautions when
reassembling
a unit after completing repairs.
Be
sure to lubricate
as required,
make
no
mistakes
when attaching parts, and avoid all other careless
mistakes that may be the cause of trouble later on.
5.1 AREAS THAT REQUIRE LUBRICATION
NOTE:
Types
of lubricants
and
areas
where
they are used are
listed in table 1.
Table 1
Areas used
Type of Oil
raising shaft
—_
all other areas
Silicon Oi! #100000
(GEM-002)
GYA-008
Lubrication
points are specified for oils other
than GYA-008.
Never use a different type of oil.
e Cam Section
Apply
oil to the heart-shaped
grooved section
(rear side of the cam) and lock plate sliding section
in order to minimize
wear on the sliding section
and the burden on the mechanism.
e Driving Plate Assembly
Decrease the burden on the mechanism and the
wear on the sliding section.
Sides, top, and bottom surfaces
(sliding section of auto-stop
mechanism)
Sides surface
:
(sliding section of
auto-stop mechanism)
EV cam side surface
(sliding section of elevation cam)
Fig. 5-1
Driving panel assembly section
© Switch Locker Section
Apply
oil to the switch locker
(opening) and
sub-panel
base
sliding
section
to
decrease
the
burden on the mechanism.
Switch locker
Fig. 5-2 Switch locker section
e
EV Lever Unit Section
Leaf spring (A)
S</
sliding section
a
aN
ie
EV lever unit
EV lever unit
sliding section
Fig. 5-3 EV lever unit section
e Elevation Cam Section
Apply oil to the elevation cam and sliding sec-
tion of the raising shaft to decrease the burden
when operated.
Elevation cam
Fig. 5-4 Elevation cam section
e EV Sheet Section
Advertisement
