Pioneer PL-2 Service Manual page 5

3.2 TONEARM
1. Disconnect the tonearm lead wires from the
PU board (See Fig. 3-2).
Note that some of the lead wires have been
soldered to the PU board, and must be discon-
nected with care.
2. Loosen the set screw @ with a screwdriver to
remove the PU plate under the arm base
(See Fig. 3-3).
3. Undo the screw @ securing the tonearm to the
arm base (See Fig. 3-3).
3.3 TONEARM SECTION
Remove the tonearm section by taking out the
three arm base attachment screws @ and one
ground wire securing screws @.
3.4 CONTROL MECHANISM SECTION
After the tonearm section has been removed,
loosen the three control mechanism attachment
screws @ and remove the assembly.
Tomearm
Screwdriver
3.5 PANEL AND BASE REASSEMBLY
1. Attach the PU cord stopper.
2. Attach the insulators. (Make certain the color-
coded float springs are attached to the correct
insulators.)
3. Attach the weight shaft assembly.
Tonearm
lead wires
PU board Red
Fig. 3-2 Disconnect the tonearm lead wires
_S-@
_ (Hexagone socket screw)
~ (2 PU plate
Fig. 3-3 Remote tonearm