Shark Cordless Detect Pro IW1600 Series Owner's Manual page 8

USING YOUR VACUUM
USING THE AUTO-EMPTY DOCK
Place the vacuum on the dock in a downward
motion. Once properly attached, the
auto evacuation process will begin. The
evacuation cycle will last for 15 seconds.
USING THE AUTO-EMPTY DOCK
QUIET MODE BUTTON LOCATION
Press the button on the top of the dock that
shows an image of a moon. This will initiate
Quiet Mode. When the dock is in Quiet Mode,
you can dock the vacuum without auto
evacuation occurring.
Note: do not remove the vacuum while the evacuation cycle is taking place.
s h a r kc l e a n . c o m
Once evacuation is complete, the vacuum
will continue charging until it is removed
from the dock.
DUST BIN FULL INDICATOR
The Dust Bin Full indicator will illuminate
when the dust bin is full of debris and needs
to be emptied. To reset the indicator, remove
the dust bin and empty it.
MAINTAINING YOUR VACUUM
CLEANING THE DUST CUP AND FILTER
With the dust cup open and the power off,
press both release buttons and slide the
dust cup out of the hand vac.
Press the tabs on both sides of the filter housing
and pull the filter out of the housing. To clean
the filter, rinse it with water only and allow it to
air-dry for at least 24 hours before reinstalling.
To reinstall the filter, slide it back into the
housing, then slide the housing back into place.
REMOVING THE HAND VAC HEPA FILTER
HEPA
Filter
IMPORTANT: DO NOT use soap when cleaning the filters. Use water only. The vacuum will not have suction if the post-motor filter is not
installed. Ensure that all filters are installed before using.
To deep-clean the dust cup, slide the release
button until the lid opens completely. Wipe
away any dust and debris with a dry cloth,
then rinse it out with water. Use a damp cloth
to remove any remaining debris. Allow the
dust cup to air-dry completely for at least
24 hours before reinstalling it.
1. To access the HEPA filter, rotate the filter
cover on the the handheld vacuum to the
unlocked position.
2. Pull off the filter cover and lift out the
HEPA filter.
3. Reinsert the filter, then replace the cover
and rotate it back to the locked position.
Regularly rinse and replace the filters to
maintain your vacuum's suction power. To
clean filters, rinse them with water only. Allow
all filters to air-dry completely for up to 48
hours before reinstalling to prevent liquid
from being drawn into electric parts.
Clean the pre-motor and post-motor filters
as least once a month. Tap off loose dirt
between washes when needed. More frequent
cleaning may sometimes be necessary with
heavy use.
s h a r kc l e a n . c o m