Table of Contents
Advertisement
Service manual for Washing Machine
Lid locked or will not open.
Does not drain or spin.
Fills with wrong temperature
water.
Load is too wet at the end of the
cycle.
Leaks water.
-------------------------------------------------------------------------------------------------------------------------------------------------------
Press the Start/Pause button to stop your washer. It may
take a few moments for the lid lock to disengage.
Straighten the drain hoses. Eliminate kinked hoses. If there
is a drain restriction, call for service.
- Close the lid and press the Start/Pause button. For your
safety your washer will not spin unless the lid is closed.
- Check the height of drain hose end.
- Turn both faucets fully.
- Make sure the temperature selection is correct.
- Make sure the hoses are connected to the correct faucets.
Flush water lines.
- Disconnect the hoses and clean the screens. The hose
filter screens may be clogged.
- Use high efficiency detergent to reduce over-sudsing.
- The load is too small. Very small loads (one or two items)
may become unbalanced and not spin out completely.
- Make sure all hose connections are tight.
- Make sure the end of the drain hose is correctly inserted
and secured to the drainage system.
- Avoid overloading.
- Use high efficiency detergent to prevent over-sudsing .
－ 23 －
Advertisement
Table of Contents
Troubleshooting
