4.3 Checking and setting the Module assembly's DIP switches.
EYFLF1
4.4 Precautions when applying the grease.
Refer to EYFLA9C/EYFMA2C Service Guide 4.6 and 4.8 except for the figures below.
Apply grease(doubrex)to the fitting surface
(hatched area) at the rear of the anvil.
Apply grease(doubrex)to the outer
circumference of the drive shaft (hatched
area).
Apply grease(doubrex)to the indicated by
the shaded area.
EYFLF2
Apply the grease(doubrex)to the steel ball side of the thrust plate.
Apply grease(doubrex)to approximately a ⌀5-mm area on each side of
the anvil
(where the anvil comes into contact with the claw part of the
hammer).
7
Apply grease(doubrex)to the fitting surface
(hatched area) at the front of the anvil.