Sapphire Pure Element PE-AM2RS485M Manual page 37

Hard Disk Boot Priority
Navigate to this section and press <Enter> to view the following screen:
1. Ch0 M. :
2. Bootable Add-in Cards
: Move Enter: Select
F5: Previous Values
Virus Warning (Disabled)
If this function is enabled and someone attempts to write data into this area, BIOS will
show a warning message on screen and alarm beep
CPU Internal Cache (Enabled)
All processors that can be installed in this motherboard use internal level 1 (L1) cache
memory to improve performance. Leave this item at the default value for better
performance.
External Cache (Enabled)
All processors that can be installed in this motherboard use an integrated Level2
cache. In older systems, the L2 cache was external and for easier differentiation from
the Level1 cache the External Cache terminology is still widely used. Disabling the L2
cache will result in a significant performance hit and should only be used for
debugging purpose
Quick Power On Self Test (Enabled)
To allow the system to skip certain tests while booting. This will decrease the time
needed to boot the system. You might like to enable this option when you are confident
that your system hardware is operating smoothly.
First/Second/Third Boot Device (Floppy/Hard Disk/CDROM)
Use these three options to select the priority and order of the devices that your system
searches for an operating system at start-up time.
Boot Other Device (Enable)
When this option enabled, the system searches all other possible locations for an
operating system if it fails to find one in the devices specified among the First, Second,
and Third boot devices.
Boot Up Floppy Seek (Enable)
When this option is enabled, it checks the size of the floppy disk drives at start-up time.
Boot Up Num Lock Status (On)
This option defines if the keyboard Num Lock key is active when your system is started,
default is on.
Phoenix - Award WorkstationBIOS CMOS Setup Utility
Hard Disk Boot Priority
WDC WD800JB-00FMA0
+/-/PU/PD: Value
F6:Fail-Safe Defaults
Item Help
Menu Level
Use < > or < > to select
a device, then press <+>
to move it up, or <-> to
move it down the list.
Press <ESC> to exit this
menu.
F10: Save ESC: Exit
F7: Optimized Defaults
SAPPHIRE PURE ELEMENT
37
F1: General Help