Samsung SC-D351 Owner's Instruction Book page 3

[ ENGLISH I
Notices and Safety instructions
VENTILAT_ON:
Slots and openings in the cabinet are provided for ventilation to
ensure reliable operation of the CAMCORDER and to protect it
from overheating. These openings must not be blocked or
covered Never place your OAMOORDER on a bed sofa, rug,
or other similar surface: on or near a radiator or heat register
This CAMOORDER should not be placed in a built-in installation
such as a bookcase or rack unless proper ventilation is provided
or the manufacturers instructions have been adhered to.
t0, POWER SOURCES:
The OAMCORDER should be operated only from the type of
power source indicated on the label
If you are not sure d the type of power supply at your home
consult your appliance deaier or local power company.
A OAMOORDER is intended to be operated from battery power
or other sources, refer to the operating instructions
tl. GROUNDING OR POLARiZATiON:
This OAMCORDER may be equipped with either a polarized
2-wire AO line plug (a plug having one blade wider than the other)
or a 3-wire grounding type plug, a plug having a third (grounding)
pin.
if you are unable to insert the plug fully into the outlet, try reversing
the plug. If the plug still fails to fit, contact your electrician to
replace your outlet. Do not defeat the safety purpose of the
polarized plug.
13. OUTDOOR ANTENNA GROUNDING:
If an outside antenna or cable system is connected to the
OAMOORDER, be sure the antenna or cable system is grounded
to provide some protection against voltage surges and built-up
static charges, Section 810 of the National Electrical Code,
ANSVNFPA No. 70-1984, provides information with respect to
proper grounding of the mast and supporting structure, grounding
of the lead-in wire and supporting structure, grounding of the mast
and supporting structure, grounding of the lead-in wire to an
antenna discharge unit, size of grounding to conductors, location
of antenna-discharge unit, connection to grounding electrodes
and requirements for the grounding electrode.
See figure below
t2, POWER-CORD PROTECTION:
Power-supply cords should be routed so that they are not likely to
be walked on or pinched by items placed upon or against them,
paying particular attention to cords or plugs, convenient
receptacles, and the point where they exit from the unit