Advertisement
Mounting to a Surface
face using fasteners (3) no more than 6.35 mm
(0.25 in) in diameter.
7.8. The amplifier assembly can be mounted
to any flat surface. Refer to Figure 3.
7.10. For masonry mounting, drill four holes
using the bracket as a guide with a masonry
7.9. For wood mounting,
d r i l l
four holes using
drill,The diameter of the holes will depend on
the
bracket
as
a
guide.
Fasten
the
the diameter of the masonry anchors you use.
Select anchors that accept fasteners no more
brackevamplifier assembly (1
&
2) to the sur-
than 6.35 (0.25 in) in diameter.
Installation
Figure 3. Surface Mounting the Distribution Amplifier
using non-HP components or accessories in
your system.
7.11. Connect the cable from the GPS an-
tenna
to
the antenna input connector.
8. MAINTENANCE
7.12. Connect the initial GPS receiver to the
8.1. There is no periodic maintenance re-
T o r t 1" connector. The receiver a t this port
quired for the distribution amplifier. However,
provides dc power to the distribution amplifier
it is recommended that all components of the
and the GPS antenna. Additional receivers
antenna system be checked periodically and
can be connected to any of the other port con-
replaced, if necessary, a s specified in company
nectors.
procedures.
Note: Option 05Q Only
-
An external dc
supply must be connected to the SMC
9.
WARRANTY
connector marked
"EXT
DC" or ANT
PWR".
The supply must be capable of
9.1. This Hewlett-Packard product is war-
providing +4.5 Vdc to +5.5 Vdc, a t least
ranted against defects in material and work-
60
mA,
less than 1% ripple.* The positive
manship for a period of eighteen months from
voltage should be connected to the SMC
date of shipment. During the warranty period,
Hewlett-Packard Company will, at its option,
center pin. All port connectors are dc-
either repair or replace products which prove
blocked, and receivers can be attached to
to
be defective.
any port connector without priority.
*
See the Caution under the section entitled,
TJse with HP and Non-HP Systems," when
Advertisement
