Advertisement
Mounting Distribution Amplifier
7.3. The HP 58516A Distribution Amplifier
can be mounted in any indoor location where it
will not be exposed to excessive humidity or
standing water. It should be placed between
the GPS receivers and any installed line am-
plifiers, and/or lightning arresters.
7.4. Refer to Figure 2. A mounting bracket (1)
is available for the HP 58516A distribution
amplifier (2). Four screws (3) attach the
bracket to the amplifier. For ordering informa-
tion, see "Parts Required," above.
7.6. The HP 58516A Distribution Amplifier is
intended for indoor use only. It can be
mounted to any flat surface.
Attaching the Bracket to the Amplifier
7.7. The distribution amplifier has four
"blind" screw holes located on the back of the
case (see Figure 2). Position the distribution
amplifier so that the four blind holes in the
amplifier case line up with the four mounting
holes at the edges of the mounting bracket.
Fasten the distribution amplifier to the
bracket using the four screws.
7.5. The bracket has four oval-shaped slots
for mounting the amplifier to a surface. These
slots are 6.35 mm (0.25 in) by 15.87 mm (0.625
in).
Figure 2. Distribution Amplifier and Mounting Bracket
Advertisement
