Table of Contents
Advertisement
2.
H
ANDLING AND STORAGE
2.1. Receipt of equipment
When transporting the device, it may be damaged by a strong shock or vibration, so the device must be inspected and, if
damage is found, photo documentation must be made to agree on further action. In case of more serious damage, it is
necessary to perform a technical inspection by an authorized partner of FLOWAIR.
The cooling equipment must be visually inspected on delivery before unloading from the vehicle. If loose or damaged
parts are found, it is necessary to contact the supplier immediately to agree on further action to resolve the situation.
The company FLOWAIR demonstrates all care to prevent damage during transport of the equipment but is not liable for
damage caused during transport of the equipment to the destination.
Immediately after unloading, check the identification data of the device stated on the nameplate (chapter Identification of
the device), and the completeness of the received documentation:
The delivery of each device includes: Technical passport, Wiring diagram, drawing with dimensions for transport mounting,
production label of the device, or protocols of the operational test. The supreme documents in terms of technical
specifications are documents with the serial number of the device (e.g. dimensional drawing with attachment points for
transport).
2.2. Manipulation
The requirements of the signs (symbols) on the packaging of the device must be observed. The basic dimensions and transport
openings and holders are shown in the drawing supplied with the device. The weight of the device is indicated on the
nameplate. Follow these rules:
Use suitable unloading / lifting equipment, lifting belts (with the capacity of the total weight of the equipment for
each belt) and other equipment.
When lifting, check the correct position of the machine's center of gravity.
Hold the device in a horizontal position. Avoid excessive rotation and tilting of the device.
The lifting gear must have adequate capacity. The weight of the device is indicated on the nameplate.
Only equipment up to a maximum total length of 3.5 m can be transported with the forklift truck. The lifting gear
(forks) must have a min. the same length as the width of the device itself. Longitudinal holes for forklift forks are
located in the devices.
The crane transports equipment with a length of more than 3.5 m, which must be lifted in accordance with the
dimensional drawing supplied with the equipment - a crane with the appropriate number of spreader bars and hinge
attachment points, which are located on the equipment frame. side).
After installing the unit at the installation site, remove the protective film and shipping fasteners.
It must be ensured that no persons are present under the suspended load during transport by crane. There is a risk of
Extreme care must be taken during transport, unloading and location of the equipment. Improper handling can damage the
device:
•
Fall to the ground even from a low height
•
Damage to belts and chains - without the use of spacers
•
Lifting for unsuitable components
•
Sudden jerk by the lifting device
•
Lifting the device at an angle - overloading the suspension points
The warranty does not cover this type of damage. In the event of the above event, it is necessary to contact an authorized
FLOWAIR partner to perform a technical inspection of the equipment.
The following figure shows the basic diagram of the suspension for vertical transport of the equipment lifted by a crane at 2,
3 and 4 points of the suspension on the frame of the equipment. For standard slings, the maximum angle between the lifting
slings (marking A) is 60 ° and between the chain slings (marking B) 45°.
! NOTICE !
!!! SAFETY WARNINGS !!!
loose parts falling.
FLOWAIR sp. z o.o. / OMSAC210708EN
8
Advertisement
Table of Contents
