Place Of Installation; Device Identification - flowair AURA HCS Series Installation And Operating Instruction

Place of installation

The installation site provided by the operator must comply with the accident prevention regulations for the machinery (EN
294: 1992 - Safety of Machinery) and related regulations. This requirement also applies to the operation, maintenance and
service of the equipment.

1.5. Device identification

The basic identification, technical and safety parameters are listed on the nameplate located visibly on the outer frame of
the device. Basic data and explanations are given below:
WATER CHILLER Cooling unit
CONDENSING UNIT Condensing unit
MODEL Model type
SERIAL N. Production identification number of the device
YEAR OF PROD. Year of Manufacture
Power supply Parameters of the electrical supply network
IP X4 Ingress protection rating
COOL Cooling mode parameters
HEAT Heating mode parameters
Pc / Ph Cooling / heating capacity
Pe Maximum electrical input
Imax Maximum allowable electric current
LRA Maximum starting current
Medium Type of cooled medium
V Nominal flow rate of the cooled medium
Dp Nominal internal evaporator pressure drop
R410a Type of refrigerant
GWP Global warming potential of the refrigerant used
Cx The amount of refrigerant charge in each circuit
Net weight Weight of the device without packaging and cooled medium
PS HP / LP Maximum allowable pressure high / low pressure side
TS HP / LP (Min. / Max.) Lowest / Highest allowable temperature high / low side
WARNING!
AURA HCS is the trade name of the device. The proper identification mark for regulatory and certification purposes is the SAC
mark. The table below shows the equivalents of the designations.
Brand Oznaczenie modelu
Aura HCS 113 SAC1-13HC-1IP4E
Aura HCS 219 SAC2-19HC-2IP4E
Aura HCS 325 SAC3-25HC-2IP3E
Aura HCS 332 SAC3-32HC-2IP4E
Aura HCS 444 SAC4-44HC-2IP3E
Aura HCS 454 SAC4-54HC-2IP4E
Aura HCS 563 SAC5-63HC-2IP3E
Aura HCS 575 SAC5-75HC-2IP4E
FLOWAIR sp. z o.o. / OMSAC210708EN 7