GE RAP02W Installation Instructions Manual page 4

STEP 4: Attach the Dual Hose Conversion
Baffle to the Back of the Air Conditioner
• From the back of your Air Conditioner, remove the two
Philips head screws holding the Intake Grille to the AC
• Remove the Air Intake Grille and filter
• Replace the Grille with the matching Dual Hose
Conversion Baffle, securing it with the two Philips head
screws.
• Use the Small Dual Hose Conversion Baffle for these
models:
APCD07JALW, APWD07JASG, APCD08JALW,
APCD08JASW, APSD08JASG, APWD08JAWW,
APLS07WWF, APLS07WWB, APLS08WWF,
APLS08WWB
• Use the Large Dual Hose Conversion Baffle for these
models:
APCD10JALW, APCD10JASG, APWD10JASG,
APWD10JAWG, APXD10JAWB, APLS10WWF,
APLS10WWB, APLH10WWF
Printed in the United States
4
Installation Instructions
STEP 5: Assemble Intake Hose Assembly
and Mount to back of Unit
Using the parts that were included in the Dual Hose
Conversion Kit, extend the intake hose approximately
4" from each end. Screw the adapters onto the ends of
the hose, turning clockwise until they are secure. Insert
the round adapter into the intake vent on the baffle you
assembled onto the AC in the previous step and turn
counter-clockwise to secure it.
STEP 6: Install Intake and Exhaust Hose
Adapters to Dual Hose Window Panel
1. Hold the Dual Hose
Window Panel so
that the L-shaped
edges of the panel
are facing you.
2. Insert the exhaust adapter
into the right side opening
in the window kit and slide
to lock it in place.
3. From the opposite side,
insert one of the flat
tipped screws through the
hole in the Window Panel
into the adapter to lock it
in place.
4. Repeat the above instructions for the intake adapter
using the left side opening.
STEP 7:
Complete the installation by continuing from Step 4 on
page 13 of the Use & Care manual that came with your
Portable Air Conditioner. For some window openings,
you may need to cut the expansion panels.
31-5000578 Rev. 2