Electrolux EW7F3816AB User Manual page 42

The indicator of the Départ/Pause
button goes off.
The door unlocks and the indicator
goes off.
1. Press button Marche/Arrêt to
deactivate the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
shows the end of the
previous programme. Turn
the programme dial to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
12.12 Draining water out after
end of cycle
If you have chosen a programme or an
option that does not empty out the water
of the last rinse, the programme is
completed, but:
• The time area shows
display shows the door locked
• The indicator of the Départ/Pause
button starts flashing.
• The drum still turns at regular
intervals to prevent creases in the
laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Essorage
button to decrease the spin speed
proposed by the appliance.
2. Press the Départ/Pause
the appliance drains the water and
spins.
The option indicator Rinse Hold
disappears.
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the Marche/Arrêt button for a
few seconds to deactivate the
appliance.
12.13 Stand-by function
The Stand-by function automatically
deactivates the appliance to reduce the
energy consumption when:
• You do not use the appliance for 5
minutes when no programme is
running.
Press the button Marche/Arrêt to
activate the appliance again.
• 5 minutes after the end of the washing
programme.
Press the Marche/Arrêt button to
activate the appliance again.
The display shows the end of the last
programme.
Turn the programme dial to set a new
cycle.
and the
If the dial is rotated to the "Reset"
.
position
turns off in 30 seconds.
button:
or
If you have set Silent
the spin speed is not
changed, when you press
the Départ/Pause
button, the appliance only
drains the water.
, the appliance automatically
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.
The remote control inhibits
the Stand-by option, but
after 15 minutes the
appliance enters in Network
Stand-by mode and the
display shows the indicator
only.
ENGLISH 41
and