Replacing Fuses - Fiat 124 SPIDER 2019 User Manual

License Plate Lights
Proceed as follows:
1. Make sure the ignition is placed in
the OFF mode, and the headlight
switch is off.
2. Slide the unit as shown in the figure
to remove it.
Trunk Lid
1 — License Plate Light Assembly
3. Turn the socket and bulb assembly
counterclockwise and remove, remove
bulb.
License Plate Light Housing
2 — Socket and Bulb Assembly
4. Install the new bulb in the reverse
order of the removal procedure. Insert
catch and push the housing back into
place.
07031501220001

REPLACING FUSES

General Information
When replacing a blown fuse, always
use an appropriate replacement fuse with
the same amp rating as the original fuse.
Never replace a fuse with another fuse of
higher amp rating. Never replace a blown
fuse with metal wires or any other material.
Do not place a fuse inside a circuit breaker
cavity or vice versa. Failure to use proper
07031501-221-001
fuses may result in serious personal injury,
fire and/or property damage.
Before replacing a fuse, make sure that
the ignition is off and that all the other
services are switched off and/or
disengaged.
If the replaced fuse blows again, contact
an authorized dealer.
If a general protection fuse for safety
systems (air bag system, braking system),
power unit systems (engine system,
transmission system) or steering system
blows, contact an authorized dealer.
Warning!
145